Search
Close this search box.
PARTS &
COMPONENTS

Car Builders Peel & Stick Heat Shield Heavy- Med

$94.99

Vehicle Fitment:
Not Vehicle Specific

In Stock

Share this product

Car Builders Peel & Stick Heat Shield pressure sensitive adhesive makes these heat shields easy and versatile to install, particularly in tight spaces. It is widely used as a thermal barrier in many industries and works effectively to block heat around fuel tanks/systems, tunnel shields, floor pans, exhaust systems, body shields, transmissions, fluid lines and to protect non ferrous materials. Constructed from a needle punched fibreglass with a polyester core and durable aluminium face that comes in two thicknesses. The product has been oven test for 30 hours with no failure at 475ºF (246ºC)​

Lite is easy to form. As the top aluminium lay is thinner (0.05mm), this product suits applications where greater versatility is required on irregular surfaces such as under bonnet, motorcycle fairings, inner guards, air boxes, batteries etc

Peel & Stick Heat Shield Heavy (0.25mm aluminium thickness) is best used for applications over flatter surfaces or near exhaust systems and heat elements use. It is also recommended for road facing applications as it has greater puncture resistance.

Pros- Direct apply to surface being protected, ideal for tight spaces. Can be applied to plastic surfaces e.g. fuel tanks. Available in two aluminum thicknesses.
Unsure which product to use? Watch our YouTube clips below.

Features/Advantages
– Light Weight
– Easily formed into place
– Very effective in limited space
– Approved at several major OEM’s
– Acoustical sound deadening benefits without the squeak or rattle issues of stampings
– Interior or exterior applications
– Easy installation – just peel off the release liner and adhere to surface.

Applications
– Fuel tank/system
– Tunnel shields
– Floor pans
– Exhaust systems
– Body shields
– Transmissions
– Steering components
– Fluid lines
– Rubber mounts
– Axle bushings

Specs:
Material Type: Polyester & Fiberglass core material
Temperature: Withstands 246ºC (475ºF) oven test for 30 hours with no failure
Core Thickness: 3mm (0.125 inch)
Foil Thickness: 0.25mm (0.010”) for the Heavy face
0.05mm (0.010”) for the Light face,
Weight: 915-1400 g/m (3-4.5 oz/ft2)
Moisture Absorption: 0.3%
Thermal Conductivity 24ºC: 0.036 W/m/ºK
(K-value) 93ºC: 0.043 W/m/ºK
Adhesion To E-Coated Steel 22.1 N/cm after 24hr Dwell
Tensile Strength 526 N/cm2
Tear Resistance 333 N/cm